GrowTech CentralHow to set up proxies in GeeLark
Step by step until GeeLark runs through the GrowTech network. About five minutes.
Before you start
- A GrowTech account with quota left (smallest purchase is 1 GB, from Rp 7.100).
- Your proxy username & password, from Console → Access.
- The application itself, installed and ready to open.
The settings you will need
Gateway addressproxy.growtechcentral.com
Rotating port823
Sticky port10000–29999
Concurrent connections5,000
The steps
- Open GeeLark, then create a new profile, or open the profile you want to use.
- Go to the proxy settings inside that profile.
- Pick HTTP as the type. SOCKS5 works too if you prefer it.
- Enter proxy.growtechcentral.com as the host and 823 as the port.
- Fill in the proxy username and password from your console.
- Hit the connection-check button in GeeLark. Green means the proxy is attached.
- Save the profile, then launch the browser from that profile.
If you get stuck
- It keeps asking for a username & password
- It wants your proxy username, not your website email. Get it from Console → Access. If you just rotated it, the old password stops working immediately.
- Connected, but the IP never changes
- You are on a sticky port. Port 823 rotates on every request; ports 10000–29999 deliberately hold one IP.
- The target still refuses me
- Try a cleaner pool (Residential Elite), or pin the country so your IP does not hop between countries mid-job.
- The connection drops midway
- Raise the tool timeout to 30 seconds. Home proxies run over real people networks, so they are naturally slower than a direct connection.
Other tools in the same family
The steps are identical — only the menu names differ.
No quota yet?
The smallest purchase is 1 GB. Datacenter is the cheapest.